San Diego Figure Skating Communications
a non-profit educational organization
This information is presented for official USFS Test Judges and individuals
whose background in skating that provides them with the technical expertise
to establish personal standards to make decisions to establish a skater's base
mark to allow for comparison and ranking skaters in a 6.0 judging environment.
Judges should take steps to make sure they don't delay the start of scheduled events
Memorize your USFS Membership Number as it is used their as well as their signature as identification on official documents such as test and competition judging sheets.
In competitions official USFS judges are assigned to events.
There is a Head or Chief Referee in charge of the competition who solves any unforeseen problems that might occur concerning scheduling judges and other problems during the competition. There are event referees whose responsibility it is to handle problems which occurr during the event.
Judges should review the rules and the required elements of the event they are assigned.
As a judge, be sure to be at the rink a minimum of a half an hour prior to the event. Visit the judges hospitality room to get warm and to obtain for food and beverages. Your judging assignment is listed the judges' schedule the referee sends out a week before the competition. A master schedule will also be posted in the judge's room. Check it as last minute changes may have occurred.
The judging clip boards may hold just one individual event. If the judging boards are not in the judges room, the event referee may have placed the judge's clipboard, event sheet(s), worksheets, and pencils at the seats in the judging area. Events may run early or late. Keep track of the progress of the event you are scheduled to judge. Arrive a few minutes early to the judging area so you don't delay the start of an event.
Sometimes the chief accounant may decide to organize the events by placing the sheets for the events in folders for each judge in the judges room. The judges put their sheets on a clipboard and carry it all day.
Always carry your updated schedule of events with your clipboard.
The accountant, will usually prepare various “work or reference sheets ” in the judges room for you to take notes. Many judges also use a 3 hole binder where they store the many competition updates. Judges carry small color coded cards with the requirements for each competitive event. Prior to the competition, make sure the cards have been updated for the current competitive season. You may bring these references with you when you judge. During the actual judging there usually will not be enough time to refer to your notes; however, you may refer to your references during warm-up periods.
Become familiar with the common abbreviations or computer codes to lessen the chance you will miss the skater performing an element while you are writing notes about the skater. Your notes should help remind you as to why you marked a skater in case of a coach requesting a clarification from the referee.
Most Open Competitions will not involve Computer Monitors on the judging stand. You will need to fill out and retain the event worksheets. Quickly transfer your marks to the “official” judging sheet that is collected and sent to the accounting room at the end of each event. In IJS the sheets are turned in after every skater has completed their performance.
Use the following evaluation standards:
PDF Marking Guide
Each official IJS judging sheet will list the Planned Program Elements the skater has turned in that he/she will perform for the event. The skater may completely revise the order and content. In 6.0 system the judges identifies the element and evaluates the quality the performance. In IJS, you should be prepared to make a call and write down what you see in case of a problem with the computer or you are unable to hear the technical specialist' calls.
The referee will indicate the length of the program in the event of a timing violation. You need to know the rules to determine what, if any, deduction should be taken.
Each event has specific required elements that must be performed. Most judges have 4x5 cards that list the elements to be performed for the event. Skaters may add change elements in a free skating program; however, if required elements are not performed correctly or not attempted - the GOE or 6.0 marks must reflect this.
Accounting Central For USFS Members only (Forms, Charts & Procedures -> IJS Charts and Factor Tables).
International Judging System (IJS) The USFS has five different sections: Technical Information, ISU Communications, Technical Panel Information - Singles, Technical Panel Information - Pairs, and Judge and Referee Information. The documents are published by the ISU or U.S. Figure Skating. It is suggested to check often on all posted documents for your event and to check the Technical Notifications/Alerts tab on the sidebar for any changes made by U.S. Figure Skating.
Figure Skating ISU Judging System The ISU International Judging System (IJS) is used in all qualifying figure skating ... The second score is the Program Components Score (PCS) ... (GOE); In determining the grade of execution the judge can mark the GOE score from -3 to +3.
ISU Figure Skating Judging
The International Judging System (IJS)
IJS Judging Criteria
Test Judging Topics
Skate Canada > Development > Programs > STARSkate Unique to Canada, this program teaches figure skating skills in a group ... Each area is divided into the following levels: ... The basic components of all disciplines of figure skating are incorporated into ... The club determines the categories which generally follow Skate Canada STARSkate guidelines (e.g. length of program,
The following internet links have been gleaned from personal communications
combined with information from public institutions and athletic organizations/
associations that have a web presence with information concerning team and
individual sports programs:
All materials are copy protected.
The limited use of the materials for education purposes is allowed providing
credit is given for the source of the materials.